ABS Nosno alloy mounts

Brennig · Post by **Brennig** » Mon Sep 10, 2012 1:52 pm

I've just ordered all the parts needed (thanks to Bens tutorial) to make a mount . I got the T-nuts from here - It was £5 for two including postage, much cheaper than everywhere else that came out to around £15
Just need to take the parts down the local garage to get them welded then I'll be ready to go. I only need to get some Trampa superstars and brake disks when they come back in stock (almost been a year now ... ) and I should have a very light brakeboard for dragging up hills.

I'll post up pics when they're done.

Ian@KentATB · Post by **Ian@KentATB** » Mon Sep 10, 2012 4:43 pm

Did Nick not have some discs going ?

Brennig · Post by **Brennig** » Mon Sep 10, 2012 4:50 pm

I have disks, but I wanna use Superstars instead of trispokes, the Trampa disks are much nicer.

Ian@KentATB · Post by **Ian@KentATB** » Mon Sep 10, 2012 5:25 pm

Don't hold your breath

Ben · Post by **Ben** » Mon Sep 10, 2012 8:39 pm

nice one, hope it all works out with the T-nut!

Brennig · Post by **Brennig** » Thu Sep 13, 2012 11:18 am

T nuts arrived, they fit perfectly! Just waiting for the exhaust clamps now, definitely the way to go if you want to save time and money. I'll post up pics when they're done. More good news too, Trampa disks came back in stock, yay! Hopefully I'll have my perfect brake board set up in no time.

Ben · Post by **Ben** » Thu Sep 13, 2012 8:49 pm

lucky badger! great to know the T-nuts work, that is a MASSIVE time saver

Brennig · Post by **Brennig** » Fri Sep 14, 2012 5:41 am

Just dropped them off at the garage, the t nut is a little to shallow so the brake rubs against the exhaust clamp but they're going to try grinding the 'angle' down on the exhaust clamp so the brake points out more. Hopefully they'll be finished within a few hours.

Ben · Post by **Ben** » Fri Sep 14, 2012 9:29 am

not sure i understand, from what i recall i thought they would have had to add a bit between the nut and the clamp, not remove....

Nick · Post by **Nick** » Fri Sep 21, 2012 5:13 am

Have you tested these out yet?

Brennig · Post by **Brennig** » Fri Sep 21, 2012 2:50 pm

I'm still waiting for the garage to weld them, they have to get another welder in to do it for me.

Surfing Dirt Mountainboard Forum

ABS Nosno alloy mounts

ABS Nosno alloy mounts

Who is online