Page 1 of 1

Full suspension mountain board bulid.

Posted: Sat Feb 27, 2016 6:36 pm
by Joe'snewboard
My name is Joe and I am going to a vocational high school, and while I was looking for a high school project I came across on google images Joshpit2003's mountain board design. I found my project. The only reson I am doing this thread is to as a thank you to Josh. I will be doing updates regularly. I will also try to show pictures and explan what eatch step I. Thank you Josh. Joe.

Posted: Sun Feb 28, 2016 1:48 pm
by BgSurfer
Please do post updates on your build. Would love to see your process/progress.

Are those foam sheets in the photo you posted above?

Update

Posted: Sun Feb 28, 2016 4:47 pm
by Joe'snewboard
Yes. What I am doing with it is shaping the rigged foam insulation to a 3rd of the intended thickness for the deck. After I am done shaping all 4( because I will screw up on one.) I turn the foam in to aluminium through magic. I'm just kidding. I bury the foam in sand vertically and pour molten aluminium in to the sand volcano funnel I construct burning away the foam and replacing it with aluminium. I sand the aluminium layers smooth, bend them to the right shape and then TIG weld the layers together. Pretty darn cool process right. Can't wait to ride. Joe

Posted: Mon Feb 29, 2016 10:53 am
by Mikael
You should document the process with photos and videos, I think I speak for many when I say we'd definitely like to see how this goes! Good luck!

Posted: Mon Feb 29, 2016 11:08 pm
by Joe'snewboard
I do not know about videos but thank you

Posted: Tue Mar 01, 2016 1:20 pm
by Mikael
Oh. Well videos are basically photos that change over time. Very cool, check one out if you can! :p

Posted: Tue Mar 01, 2016 1:32 pm
by Flexboardz
Agree 100%

Posted: Tue Mar 01, 2016 7:18 pm
by Joe'snewboard
Can you tell me how to upload videos then? That is the only thing holding me back.

Posted: Tue Mar 01, 2016 9:22 pm
by Mikael
There's this little website that should let you upload them: https://www.youtube.com

At this point, I don't know if you're trolling me or if I'm trolling you!

Posted: Wed Mar 02, 2016 1:00 am
by Joe'snewboard
No no no I have never uploaded a video on to the internet before. I am going to google it tomarrow. I will figure it out I have faith. Please no trolls on this website this is for dirt surfing only.

Posted: Wed Mar 02, 2016 3:26 pm
by BgSurfer
I have uploaded videos to Youtube and Vimeo. Fairly simple. Don't know if it has changed but videos uploaded to Vimeo seem to have better resolution.

Your aluminum molding process sounds interesting. Not quite sure I understand the process though.

If you can't post video, picture sequences work well enough.