Page 1 of 1

Nosno stencil

Posted: Thu Feb 02, 2012 7:47 am
by Brennig
Yo,

Can anyone be a very big help and draw out the dimensions of a nosno hanger. I'll need one when cutting holes in the tips and so on, so I can make it compatible with noSno trucks. It would be an even bigger help if someone could do the same with the composite axles (new ones), do i have a stencil to cut out the deck for making the trucks, and it would be even even better if they were the axles for holding disk brakes ! I'm asking a bit much, but it's for the good of mountainboarding !


Image

Posted: Sun Sep 14, 2014 12:41 pm
by mario64
Did you get a stencil? I'm going to try out making a nompa, but i wanna do some tests on my old deck so i need to know the dimensions for the nosno axels. i really just need the distance between the centre of the holes and how big the holes are.

Posted: Mon Sep 15, 2014 4:32 am
by Daleyg3
I have the picture somewhere, will fb message it you man!

Posted: Mon Sep 15, 2014 12:10 pm
by mario64
Cheers Daleyg3, can't wait to try making a nompa

Posted: Tue Sep 16, 2014 3:13 am
by Daleyg3
Add me on Facebook man.. 'Dale Goodwin' Don't know your second name.